Raspberry Pi Compute Module 5 Programming Jig

Description

The Raspberry Pi Compute Module 5 Programming Jig has been
designed to allow OEM customers using any of our Compute Module
5 range of boards to efficiently load operating system images into
the onboard eMMC Flash during their production process.
Programming time per board will vary with the size of the operating
system image being loaded. It is expected that higher-volume
customers will operate multiple units in parallel to achieve the
desired throughput.
• Single-head design provisions one Compute Module 5 at a time.
• Mechanical clamping secures the Compute Module 5 in place
during programming.
• Pogo pin interface connects directly to Compute Module 5 without
a carrier board.
• LED status indicators communicate the current state of the jig and
provisioning progress.
• Dual network connectivity connects the jig to the provisioning
network by Ethernet (JIG ETH) or Wi-Fi, with a second Ethernet
port (DUT ETH) for accelerated software transfer to the Compute
Module 5 being programmed.
• Automated provisioning supports secure boot, full-disk
encryption, and bare operating system installation.
• Compatible with Compute Module 5 (CM5) only