Mini Stepper Motor – 200 Steps – 20x30mm NEMA-8 Size

Mini Stepper Motor – 200 Steps – 20x30mm NEMA-8 Size




Disponibile: Esaurito COD: AD4411-B8 Categorie: ,

Informami quando l'articolo è disponibile.


This tiny stepper motor is the same quality and step-size as the big NEMA-17's we stock, but so cute so it will work with compact CNC builds. This 4-wire bipolar stepper has 1.8° per step for smooth motion and a nice holding torque. The motor was specified to have a max current of 600mA so that it could be driven easily with an Adafruit motor shield for Arduino, Motor Bonnet for Raspberry Pi or our Feather Motor controller & and a wall adapter or lead-acid battery. It's rated for 3.9V, if you have a stepper driver with current limiting, use that to keep the power down. If you have a non-current-limiting driver such as the motor shield/hat/feather we found 5V DC power worked well to power the stepper controller.

The cable has ready-to-go wires – the drive-shaft does not have a D cut in it, but you can clamp to it pretty easily. We drove it with an Adafruit motor shield for Arduino and it hummed along nicely at 50 RPM. To connect to our shield/hat/featherwing, put the wires in this order: Black, Red, skip ground if there is one, Green, Yellow.



Bipolar stepper, requires 2 full H-bridges!
4-wire, approx ~16″ leads
33mm x  20mm rectangle body
4mm diameter drive shaft, ~9mm long
3.9V rated voltage (you can drive it at a lower voltage, but the torque will drop) at 600mA max current
28 oz*in, 20 N*cm, 2 Kg*cm holding torque per phase
35 ohms per winding



Informazioni aggiuntive

Peso 0.2 kg
Dimensioni 5 × 5 × 5 cm