Particle Relay Shield

Description

The Relay Shield allows you to check up to 4 sockets via your Photon, wherever you are.

Operating voltage: 7 - 15V DC
Current consumption: 150mA min to 290mA (@ 9V DC)
Maximum voltage for relay: 250V AC
Maximum current per relay: 10Amp @ 125V AC

To work it requires a 7-15V power supply and at least 1A, not included. The connector for the power supply is a 5.5mm barrel jack.

Photon is the development board for the Internet of Things (IoT) created by Particle (originally Spark). The first thing to say about this product is that, once out of the box, it takes 5 minutes to connect it to the internet via WiFi and control it via an app available for free for iOS (version 8.0 up) and Android (version 4.0.3 up). ). And this is only the beginning. Thanks to the services offered by websites such as IFTT.com (free) you can receive notifications on your smartphone when the conditions you set occur, perhaps relating to the values ​​detected by the sensors you decide to connect. The Photon can be reprogrammed with the Arduino language remotely, through the web platform available at https://build.particle.io or using the IDE that can be downloaded for free from https://www.particle.io/dev, just an internet connection.
Technical data:

 Wi-Fi Particle PØ Module

Broadcom BCM43362 Wi-Fi chip
802.11b / g / n Wi-Fi
STM32F205 120Mhz ARM Cortex M3
1MB flash, 128KB RAM

RGB status LEDs
18 Mixed-signal GPIO
open source design
Real-time Operating System (FreeRTOS)
Soft AP setup
FCC, CE and IC certificate

TECHNICAL INFO:
Producer's page
Quick guide and technical documentation
Particle IDE
Particle Web IDE

Product information