Adafruit MacroPad RP2040 Starter Kit - 3 × 4 Keys + Encoder + OLED - ADABOX019 Essentials
57,34 €
Notify me when the item is available.
- Description
- Product information
Description
Starter Pack Includes:
- 1 x Adafruit MacroPad RP2040 - 3 × 4 Keys + Encoder + OLED
- 12 x Kailh Mechanical Key Switches - Linear Red
- 12 x Clear Keycaps for MX Compatible Switches
- Adafruit MacroPad enclosure kit:
- 1 x Adafruit Macro Pad bottom plate
- 1 x 3 × 4 Mechanical keyboard plate
- 1 x D-Shaft Skirted Rubber Knob (Same as used at https://www.adafruit.com/product/377)
- 4 x M3 5mm machine screw
- 4 x Rubber feet
Get ready to upgrade your desk's mission control station with a CircuitPython or Arduino powered Macropad - complete with 12 buttons, OLED display, speaker and rotary encoder. Customize it for your spacecraft to help guide you through the great reaches of the unknown. (Or just have it type out your favorite emojis.)
Each of the 12 sockets can accept a Cherry MX-compatible key switch. No soldering required, just snap the keys in!
Dress up your Adafruit Macropad with PaintYourDragon's fabulous decorative silkscreen enclosure and hardware kit. You get the two custom PCBs that are cut to act as a protective bottom plate and a mechanically-stabilizing keyboard plate.
Use the included M3 screws to attach the bottom plate - it's symmetric so you can decide which side you'd like to have visible. Stick the rubber feet on the bottom to protect your desk from scratches. Fit the 12 keys you'd like to install into the keyplate, they'll snap in solidly and let you plug in all the keys at once. Finally, fit the D-shaft knob onto the encoder.
Lookin 'good and ready to keeb!
- Raspberry Pi RP2040 Chip + 8MB Flash memory - Dual core Cortex M0 + at ~ 130MHz with 264KB or RAM. Runs CircuitPython, Arduino or MicroPython with ease and lots of space for development code and files
- USB C Connector for Power / Data - of course this can act as an HID device but also can be MIDI, UART, etc.
- 3 × 4 Mechanical key switch sockets - accepts any Cherry MX-compatible switches. Individually tied to GPIO pins (not matrix wired)
- One NeoPixel RGB LED for switch, on the north side
- Rotary encoder, 20 detents per rotation, with push-switch on GPIO pin. Push switch is also used for entering bootloader mode when held down on power-up or reset.
- 128 × 64 SH1106 Monochrome OLED display - On high speed hardware SPI port for quick updates
- 8mm Speaker / Buzzer - With Class D amplifier and RC filter, can be used to make simple beeps and sounds effects.
- QT Connector EMBLEM - Allows adding any I2C sensors / displays / devices with plug-and-play cables.
- Reset button - On the side, for quick restarting of code
- Four M3 mounting bosses - Make custom enclosures easily
Product information
BRAND | Adafruit |
---|