Standalone 5-Pad Capacitive Touch Sensor Breakout – AT42QT1070
9,62€ IVA INCLUSA
1-2 | 9,62€ |
3-5 | 9,43€ |
6+ | 9,24€ |
- Descrizione
- Informazioni aggiuntive
Descrizione
This breakout board is the simplest way to create a project with mutiple capacitive touch sensors. No microcontroller is required here – just power with 1.8 to 5.5VDC and connect up to 5 conductive pads to the 5 left-hand pins. When a capacitive load is detected (e.g. a person touches one of the conductive contacts) the corresponding LED on the right lights up and the output pin goes low. You can use this to update an existing normal-button project where buttons connect to ground when pressed.
Note that only one contact will be detected at once (this is to protect against having a hand brush against two or more contacts at once.
Comes with a fully assembled board, and a stick of 0.1″ header so you can plug it into a breadboard. For contacts, we suggest using copper foil, then solder a wire that connects from the foil pad to the breakout.
The datasheet has many details on sensitivity, power usage, etc. – note that this board uses the chip in ‘standalone’ mode only, it cannot be used in I2C mode.
Informazioni aggiuntive
Peso | 0.05 kg |
---|---|
Dimensioni | 5 × 1 × 3 cm |
Brand | Adafruit |