Arduino Micro (with headers)

Arduino Micro (with headers)

18,98 

Esaurito

18,98 

Versione disponibile:: Esaurito COD: ARD-RA000053 Categorie: ,

Informami quando l'articolo è disponibile.

Descrizione

The Arduino Micro is a microcontroller board based on the ATmega32u4 (datasheet), developed in conjunction with Adafruit. It has 20 digital input/output pins (of which 7 can be used as PWM outputs and 12 as analog inputs), a 16 MHz crystal oscillator, a micro USB connection, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a micro USB cable to get started. It has a form factor that enables it to be easily placed on a breadboard.

The Micro is similar to the Arduino Leonardo in that the ATmega32u4 has built-in USB communication, eliminating the need for a secondary processor. This allows the Micro to appear to a connected computer as a mouse and keyboard, in addition to a virtual (CDC) serial / COM port. It also has other implications for the behavior of the board.

Microcontroller
ATmega32u4

Operating Voltage
5V

Input Voltage (recommended)
7-12V

Input Voltage (limits)
6-20V

Digital I/O Pins
20

PWM Channels
7

Analog Input Channels
12

DC Current per I/O Pin
40 mA

DC Current for 3.3V Pin
50 mA

Flash Memory
32 KB (ATmega32u4) of which 4 KB used by bootloader

SRAM
2.5 KB (ATmega32u4)

EEPROM
1 KB (ATmega32u4)

Clock Speed
16 MHz

Length
48 mm

Width
18 mm

Weight
13 g

The board can operate on an external supply of 6 to 20 volts. If supplied with less than 7V, however, the 5V pin may supply less than five volts and the board may be unstable. If using more than 12V, the voltage regulator may overheat and damage the board. The recommended range is 7 to 12 volts.

The power pins are as follows:

VIN: The input voltage to the Arduino board when it's using an external power source (as opposed to 5 volts from the USB connection or other regulated power source). You can supply voltage through this pin.
5V: The regulated power supply used to power the microcontroller and other components on the board. This can come either from VIN via an on-board regulator, or be supplied by USB or another regulated 5V supply.
3V: A 3.3 volt supply generated by the on-board regulator. Maximum current draw is 50 mA.
GND: Ground pins.

INFO TECNICHE:
Pagina del Produttore
ATmega32u4 datasheet
EAGLE CAD files
Schematic [pdf]

Informazioni aggiuntive

Peso 0,05 kg
Dimensioni 5 × 1 × 3 cm
Produttore

Senza marca/Generico

MPN

ARD-RA000053

Brand

Arduino