ARDUINO MKR1000 WIFI WITH HEADERS MOUNTED
45,31€ VAT INCLUDED
Arduino MKR1000 is a powerful board that combines the functionality of the Zero and the Wi-Fi Shield. It is the ideal solution for makers wanting to design IoT projects with minimal previous experience in networking.
Notify me when an item is available again.
- Additional information
Arduino MKR1000 has been designed to offer practical and effective solution for makers seeking to add Wi-Fi connectivity to their projects with minimal experience in networking.It is based on the Atmel ATSAMW25 SoC (System on Chip), that is part of the SmartConnect family of Atmel Wireless devices, specifically designed for IoT projects and devices.
The ATSAMW25 is composed of three main blocks:
- SAMD21 Cortex-M0 + 32bit low power ARM MCU
- WINC1500 low power 2.4GHz IEEE® 802.11 b / g / n Wi-Fi
- ECC508 CryptoAuthentication
The ATSAMW25 includes also a single 1 × 1 stream Antenna PCB.
The design includes a Li-Po charging circuit that allows the Arduino / Genuine MKR1000 to run on battery power or external 5V, charging the Li-Po battery while running on external power. Switching from one source to the other is done automatically. A good 32 bit computational power similar to the Zero board, the usual rich set of I / O interfaces, low power Wi-Fi with a Cryptochip for secure communication, and the ease of use of the Arduino Software (IDE) for code development and programming. All these features make the board the preferred choice for the emerging IE battery-powered projects in compact form factor.The USB port can be used to supply power (5V) to the board.The Arduino MKR1000 is able to run with or without the Li-Po battery connected and has limited power consumption.
The MKR1000 Wifi module supports SHA-256 certificate.
Warning: Unlike most Arduino & Genuino boards, the MKR1000 runs at 3.3V. The maximum voltage that the I / O pins can tolerate is 3.3V. Applying voltages higher than 3.3V to any I / O pin could damage the board. While output to 5V digital devices is possible, bidirectional communication with 5V devices needs proper level shifting.
You can find here your board warranty information.
You can find in the Getting Started section all the information you need to configure your board, use the Arduino Software (IDE), and start tinker with coding and electronics. Full details and examples on how to use the WiFi interface are available in the WiFi101 Library reference page.
|microcontrollers||SAMD21 Cortex-M0 + 32bit low power ARM MCU|
|Board Power Supply (USB / VIN)||5V|
|Supported Battery (*)||Li-Po single cell, 3.7V, 700mAh minimum|
|Circuit Operating Voltage||3.3V|
|Digital I / O Pins||8|
|PWM Pins||12 (0, 1, 2, 3, 4, 5, 6, 7, 8, A10 - or 3 -, A18 -or 4)|
|Analog Input Pins||7 (ADC 8 / 10 / 12 bit)|
|Analog Output Pins||1 (DAC 10 bit)|
|External Interrupts||8 (0, 1, 4, 5, 6, 7, 8, A1 -or 16-, A2 - or 17)|
|DC Current for I / O Pin||7 mA|
|Flash Memory||256 KB|
|Clock Speed||32.768 kHz (RTC), 48 MHz|
|Full-Speed USB Device and embedded Host|
|Dimensions||5 × 1 × 3 cm|